BenQ W2720i Calibration Settings

Updated 
For additional settings information, please consult the Common Problems and How to Calibrate pages.

We used the following calibration settings to test the BenQ W2720i. Keep in mind that results can vary slightly between individual units, firmware versions, and picture modes, so you may need small tweaks if your unit looks a bit different.

These settings are meant to provide a solid starting point for accurate SDR playback in a typical living room. They aren't meant to be copied 1:1, and your best results will depend on your screen size, throw distance, room brightness, and wall/screen color.

SDR Picture Settings

BenQ W2720i Calibration Settings 7
BenQ W2720i Calibration Settings 11

For SDR content, you can choose a few different preset picture modes. We used FILMMAKER MODE because it's the most accurate out of the box and allows for the most customization, including adjusting the projector's white balance (see below). All other settings were either left to default, disabled, or left off.

  • Picture Mode: FILMMAKER MODE
  • Brightness: 50
  • Contrast: 50
  • Color: 50
  • Tint: 50
  • Sharpness: 0
  • Gamma Selection: 2.1
  • Color Temperature: Normal
  • LightSource: High Dynamic

Gaming Settings

BenQ W2720i Calibration Settings 9

From the base SDR settings, very few changes are required for the best gaming experience. When you start gaming, it's best to enable Fast Mode, since it provides the lowest input lag. The rest of our gaming settings are identical to our regular settings for SDR.

Fast Mode: On

Firmware

BenQ W2720i Calibration Settings 30

The unit we bought and tested was calibrated on software version 1.0.2.

Other Settings

For information on any other settings or features that fall outside of the scope of our testing, please refer to BenQ's support page for this projector.

White Balance Settings

The following are the results of our unit's white balance and colorspace calibration. They're provided for reference and shouldn't be copied, as the calibration values vary per individual unit due to manufacturing tolerances. If you want to try them, you'll need to enter all the values shown, as all of them are active at the same time. If you end up with worse picture quality, simply reset them to the default values.

BenQ W2720i Calibration Settings 12
BenQ W2720i Calibration Settings 13
BenQ W2720i Calibration Settings 14